Edge Microgate Offline

Table of Contents

• Introduction
• Edge Location(s)
• Edge Verification
• Edge Powercycle

                                    Introduction

Use the following instructions to help locate and powercycle your Edge Microgate

Your site may have a different model of Edge that will have different outside covering and DFS Labels.

                                     Edge Location(s)

Site may have a Wall Setup, Under Counter Setup, or variation of both (see pictures below)

Alternate location: office area or located near the ISP (Internet Service Provider) Modem

Edge Verification

Verify Power on the Edge Microgate (Blue LED is located opposite side of the Power Button)

If Blue LED is OFF then Power ON the unit by pressing the Power Button (Blue LED will illuminate)

If Edge Microgate will not Power ON, trouble shoot the Power Issue 

Check outlet power > Replace Power brick and/or cord (if available) > Replace Edge (Contact ASO)

(DFS Devices require a UPS (Uninterrupted Power Supply) or Surge Protected power strip)

Edge Powercycle

Microgate only controls DX Solutions a Powercycle will not interrupt Fuel Operations

P/N WU019240-0003 - Hold the power button down until the Blue LED goes OFF (See Above)

Wait 30 secs and Press POWER button (Blue LED will Illuminate)

P/N WU019240-0004 - Press the power button to turn OFF the Edge (See Below)

Powercyle the Microgate by holding the POWER button down until the Blue light goes Off

Wait 30 secs and Press POWER button to power back on (Blue LED will Illuminate)

For Hardware or Network issues please refer to a local Service Provider or appropriate Help Desk

To Submit a Service Request Click here

Return to top